Learning to use paste wax on hardwood floors

I live in a 1940s home with original hardwood floors. I decided to use paste wax because the finish was worn and dull. I have tried liquid wax, but it wears off too fast. In my case, it was less than a month. I read that paste wax lasts several months and decided to use it on my hardwood floors.

I did some research and read several terrifying articles about how to prepare the floors and apply the paste wax. I did not want to sand or use steel wool on anything. And I was not going to apply the paste wax by hand. My house is entirely hardwood. I could not move all the furniture out. Yet none of the research told me how to get the paste wax out of the can and onto the floor.

I had to devise my own methods. I chose a flip mop for wax application. This has a detachable, washable cover and is soft enough to hold the wax. I am too small to move the furniture, and I had nowhere to put it anyway, since I was doing all the floors.

I used my Mighty Mite floor vacuum (which will suck the paint off the walls) and mopped the floors with my usual cleaner. I do own a Cleaning Machine with buffing attachments, so when the floors dried, I was good to go.

First, I took a small handful of the wax and threw it on the floor. I placed the flip mop on the glob of paste wax, centering it on top of the paste wax. I moved the flip mop from left to right to work the wax into the soft fabric. Then I applied the paste wax, spreading a thin layer on the floor. I did have to use a rag in the smaller places. It took about an hour to apply the wax throughout the house: two bedrooms, the hallway, the living room, and the dining room.

I set the timer for 30 minutes after I finished all the floors. I relaxed outside. When the time was up, I put the buffing pads on my Cleaning Machine and began buffing the first room I waxed. If the wax gets too thick, the buffing pads will fly off the machine. I learned this.

I continued buffing and putting the pads back on until the entire house was buffed. I used the polisher pads a few hours later and again the next day. It takes about two days for the paste wax to cure. I had to go back to the places where I put the wax on too thickly over the next two days. So be careful when spreading the wax.

The next coating will go on with a Swiffer. The sturdy paper will be more porous and apply the paste wax better.

The floors look very good. The entire process took about 2.5 hours. It was not terrifying. I didn’t need sanding and mineral spirits. I just required paste wax, an applicator, and a buffer.